Silver Peel-and-Stick Kitchen Liner — 3 Finishes, 2 Sizes

A silver refresh for the shelves
and drawers you use every day.

Give a plain, suitable surface a new silver look with a flexible peel-and-stick liner. Measure your space, trim the sheet, peel the backing and smooth it into place—no separate glue to mix or spread.

• 3 silver finishes: Floral, Diamond and Smooth.
• 2 roll sizes: 15.7 × 39.4 in or 23.6 × 39.4 in.
• Sold individually: one roll per unit ordered.

Start with a shelf, drawer base or cool decorative panel. A small area gives you a manageable cutting and fitting project; check surface compatibility in a hidden spot first.

Same silver palette.
Three different surface looks.

Choose by pattern, rather than color: all three finishes are silver, and every finish comes in both widths.

Shine and apparent shade vary with room lighting and your screen. Use the illustrations to compare styles, rather than to match an exact metallic tone.

Choose one useful place to start.

This is a thin decorative covering with adhesive backing. It changes the surface appearance; it does not level damaged material or perform the job of a rigid backsplash panel.

Choose the width.
Both rolls are 39.4 inches long.

Dimensions are approximate. Areas are calculated from the listed metric dimensions before trimming; actual usable coverage is lower after cuts, seams and pattern alignment. A 39.4-inch roll is approximately 3.28 feet long.

A practical fit check: An 18 × 30-inch section fits inside the nominal 23.6 × 39.4-inch roll before allowing for your chosen trim margin. It will not fit as a single piece inside the narrower roll, even if the total square footage sounds sufficient.

How many rolls should you order?

1. Measure every section’s width and length.
2. Sketch each piece within a roll of your chosen size.
3. Allow for trimming, corners, joins and matching the pattern direction.
4. Count the rolls required by your cutting plan, rather than using area alone.

Quantity 1 = 1 roll. Quantity 2 = 2 rolls. Quantity 3 = 3 rolls. Multiple rolls are separate units; a continuous longer sheet is not promised. Add different finishes or sizes to your cart separately.

Check the surface before you commit.

Keep the liner away from open flames, burners and hot cookware. It is a decorative covering, not a heat shield or a watertight seal. No tested heat rating is available for this listing.

Adhesive may leave residue or lift an existing finish when removed. If you rent or are covering a delicate surface, check permission and compatibility before application.

Measure. Cut. Peel. Smooth.

1. Prepare: Clean the surface, remove grease and moisture, let it dry, then test a hidden spot.
2. Measure and cut: Check the finish direction, mark your piece and use suitable scissors or a craft knife on a protected cutting surface.
3. Peel gradually: Align the first edge, then remove the backing a little at a time. Avoid stretching the sheet or creating sharp creases.
4. Smooth gently: Work from the center toward the edges with a soft cloth. Finish corners and joins carefully, without forcing the film over awkward joints.

Work on one manageable section at a time. If you are covering several adjacent pieces, plan the joins and pattern direction before peeling any backing.

A straightforward wipe-down routine.

For routine care, use a soft, lightly damp cloth, then dry the surface. Wipe fresh splashes promptly and clean the embossed finishes gently.

• Keep abrasive pads, harsh solvents and sharp tools away from the installed film.
• Avoid flooding joins or leaving standing liquid at the edges.
• Use a separate cutting board and keep hot pans off the covering.

The supplied specification describes oil- and stain-resistant use. This is not a promise that every mark will wipe away, that seams are waterproof, or that the liner is suitable for direct food contact.

What arrives in your order.

Product, application and process visuals on this page are illustrations. They help explain the intended appearance and use; they do not establish adhesion life, heat resistance or a guaranteed installation result.

A few final checks before ordering.

Delivery, returns and your next step.

See our current Shipping Policy for delivery estimates, destinations and charges. Transit estimates run from dispatch.

Read the Refund Policy before ordering or cutting the liner. For questions about return eligibility for this item, contact info@getchairisma.com.

Ready to choose? Select Floral, Diamond or Smooth in the product options, choose your roll size, set the number of rolls and add your selection to the cart.